Each controller module comes with a small pushbutton that has multiple modes. When playing animations, the button allows you to toggle between 3 brightness levels. You can also use this button to boot the system into configuration mode so you can change your animation que:
With the device powered OFF:
- HOLD DOWN the push button the back of the control module
- Connect the device to power
- Count to 3 and the device will now boot into configuration mode (no lights will light up just yet)
On your phone/tablet open your WIFI settings and connect to the network named “WOW-APP” Passkey “wowaccesspoint” Once connected your device may advise you that there is no internet, ignore this message and continue to connect to it
Open your devices web browser and go to the following web address http://10.10.10.1
Your devices configuration page will load
Each row is a different animation. The animation is selected by tapping the animation name drop down and selecting it from the list
To preview the animation LIVE, Tap on the PLAY button on the LEFT
Tap on it again to stop the preview. The Preview will play for the duration listed in the duration field and the brightness levels indicated by the slider.
You can set a different duration for each animation by tapping into the DURATION field
Animations can have a duration of 0 to 32,000 seconds. If you set it to 0 the animation will just skip over.
You can also set different brightness levels for any animations. There are 3 LEVELS of brightness.
If you slide the brightness slider all the way to the LEFT its at 100%. If you set it to the middle, its at 50% and if you slide it to the RIGHT its at 25%.
You can delete any animation in QUE by tapping on the RED CROSS on the right
To add more animations to your que, scroll down to the bottom of the page and tap on Add Animation:
If at any point you want to clear everything and start with the default playlist tap on “Reset to Default”
Once you are happy with the que tap on “Save & Start Playing”
